I have a feeling I'm not taking advantage of this great monitor for my Mister FPGA. I have the mister hooked up with a VGA -> RGB cable in the back of the monitor. This monitor can handle many types of resolutions. Currently, it seems like the monitor …

I didn't have a working mouse for my //c. That ended earlier this week.A tweak of an earlier design I used for Atari ST using a WinChipHead (Nanjing Qinheng Microelectronics) CH series microcontroller. The perf board prototype works great and PCB's are on …

Hello, gentlemen!After consulting Saturn 128k manual, this forum and other sources content I have the following question: is it possible to make a RAM/Card test at the 128k card without any input device where a program can run from?I could not find any inf …

I can't get a signal on my CRT monitor (or better, the monitor is getting something because it doesn't display the "no connection" message, but I'm not getting a picture). I'm using an HDMI-VGA converter and my monitor is a standard PC monitor, it can sup …

This adds the following commands to basic HGR Hires Grahics On HGROFF Hires Graphics Off HFCOL Hires Fore Color HBCOL Hires Back Color HCLS Hires Clear Screen HLINE Hires Line HPLOT …

Hi,I have created my own Joystick interface and all my development has been done on devices other than the mister, but now I've come to the point of starting to test it with my MiSTer I've suddenly hit a problem, it doesn't work.I did have it briefly work …

I built a MiSTer Multisystem recently and after a few initial problems everything seemed to be working ok. I had the MMS and my PC connected to the same monitor, PC via DVI and MMS through VGA. So no problems, I just switched between the 2 inputs direct f …

Hi!I am trying to display ao486 on a 15khz 1084s monitor.It kind of works but the image is slightly stretched vertically. This results in some doubled lines which is nasty. The image also slightly cropped vertically. core is at: 320x200 70hzoutput is at: …

Hey,after hours and hours of tinkering I have my arcade basically 99.9% setup and that makes me super happy but there is a single remaining Issue I am unable to understand or solve.I am using an IPAC2 in keyboard mode for my arcade controls. The joystick …

Hi all, I have a working setup that runs other games fine, but MAPPY does not sync at all. I am using a Component video cable, here is my mister.ini:[MiSTer]key_menu... ; set to 1 to make the MENU key map to RGUI in Minimig (e.g. for Right Ami …

News from the MorphOS Team: The MorphOS development team is proud to announce the public release of MorphOS 3.18! This new release includes several new applications such as Hex - a scriptable file/RAM/disk hex editor, ArchiveIt - a ZIP archiver/unarchive …